Metra 95-5812 Double DIN Installation Kit Fits SELECT 2004-2019 Ford Vehicles -Black.

Just finished installing this with aPioneer AVH-P3400BHDouble DIN in my 2005 Ford Focus. Ultimately, it worked and it looks good. But, it wasn’t brain dead easy; my notes:* The instruction are a little confusing (for my vehicle, the instructions mention not breaking off the back tabs…and says, all other vehicles, move to step 2) Where was my step 2?! My take, the instructions for all vehicles are pretty much identical except some vehicles remove the back tabs, and some need to install the provided spacers).* Because of the curvature of the face plate of the adapter (due to the curvature of the car stereo area in general), it was a little off putting that the faceplate and the radio didn’t align perfectly corner to corner when I was setting things up out of the car. This isn’t a fault of the adapter, just the reality of putting a perfectly flat headunit into a non-uniformly curved opening …once it is installed into the car, this difference was much less noticeable.* The fit of the radio adapter in the car was tight. Much less smooth than getting the factory stereo in and out. I needed to gingerly push the side mounting brackets to get things to finally seat squarely in the dash.* The mounting holes of the adapter didn’t perfectly align with the holes in the dash. I could get everything in though.* The 4 mounting screws provided where smaller than the factory screws I took out. For me, they were too small and didn’t catch securely. Fortunately, I just reused the factory mounting screws with no problem.If you are not deterred by the finer points of the installation mentioned above, I don’t think you should any problems with this vehicle and head-unit.